Sunday, December 17, 2017
sliding panda card. I got a few questions over the weekend on how the sliding mechanism was made so I updated that post with some more details. This card works with a similar theory, this one is slightly more complicated but still works the same way. I encourage you to check the panda post for the basics of the slider. For the unicorn I cut the channel with the framelit I used for the red layer of the rainbow. The rainbow is adhered right over the channel so you can't see it but it's there! To make the slider I did it the same way as the panda. There's a piece of cardstock behind the channel, then a dimensional in the channel-this time a mini one! Then instead of adhering my image to the front of the dimensional I adhered a small piece of a window sheet. If I would have adhered the unicorn right on top of the dimensional my unicorn would have been behind my rainbow. So instead I added a window sheet on it. The window sheet is probably only an inch tall and about 1/2" wide, but it's tall enough to stick up over the rainbow. Where the window sheet is sticking up is where you add your unicorn again with a dimensional. Again make sure you look at my panda post to see the sliding card basics.
Thanks for looking, see you soon!!!